Aims and purposes of this document
The purpose of this document is to provide a reference for connecting, commissioning and operating the DPM-MC2 Communication Card.
Use of the card
The DPM-MC2 card can only be used in MICRO PANEL MC2 series devices equipped with the corresponding slot.
The DPM-MC2 card is a PROFIBUS master. The development is based on the EN50170 standard.
The card can only be mounted and dismounted when the device is powered off.
Function and control indicators
Connector assignment
The plug connectors and connector assignment comply with the www.abb-drive.com Profibus standard (EN50170). Only the transceiver signals and the power terminals for line termination are provided.
The power supply terminals DGND (0V, pin 5) and VP (+5V, pin 6) are only intended for powering the cable terminals (terminals) and must not be used for any other purpose. the CNTR-P signal (pin 4) is used in conjunction with a repeater.
Bus segments must be terminated at both ends.
No more than 2 bus terminals must be activated per bus segment!
At least one of the two bus terminals must be powered by the bus station!
Maintenance, repair, disposal
Maintenance
Repairs can only be carried out by the manufacturer or an authorized service center. In this case, please contact your local MICRO PANEL dealer or Micro Innovation’s technical support department.
The warranty does not apply if any modifications are made to the device that are not described in this document.
Shipping
The original packaging must be used when transporting the device.
Disposal
Memory cards that are no longer in use must be disposed of properly or returned to the manufacturer or seller for proper disposal.
Leave a comment
Your email address will not be published. Required fields are marked *