The IC660BBD022 is a Genius protocol-enabled module that is part of the Genius I/O Block series of distributed I/O modules. The device is a stand-alone, single node I/O station with sixteen (16) I/O circuits that supports source-wired configurations.The IC660BBD022 has sixteen (16) I/O circuits and operates at 24 / 48 VDC.Each channel of the module can be configured as an input and an output, and is capable of exchanging data over the supplied Genius I/O Bus Terminal, allowing the module to be used in a wide variety of applications including GE Programmable Logic and Automation Controllers (PLC / PAC) as well as Bus Controllers, PC Interface Modules, www.abb-drive.com Human Machine Interfaces (HMI) and third party devices. The module is a panel-mounted, self-contained device in an open enclosure, so it must be mounted inside the enclosure to provide adequate protection from industrial contaminants. The module can be mounted remotely with a maximum distance of 7.500 feet from partner equipment. It also allows daisy-chaining of other I/O modules to form a Genius I/O network. Operation of the module can be configured locally using a handheld monitor (HHM) through the HHM port mounted on top of the terminal assembly. It can also be configured remotely using the host controller’s programming software. The module’s input channels accept 12 / 24 VDC nominal voltage with a 1.7 ms start-up delay. Similarly, the output channels generate 2 amps of current per circuit with a maximum turn-on delay of 1 ms. The module consists of two (2) assemblies, specifically the IC660EBD020 electronics assembly and the IC660TBD022 terminal base assembly.

The IC660BBD022 I/O module is a 16 circuit enabled source I/O module manufactured by GE Fanuc. It uses a 24-volt DC power supply and can be used with both 2-wire and 3-wire sensors.The Genius I/O device has a load current of 2 amps, and this DC power block has intelligence that makes it easy to configure as a sensor or actuator device. It also has other configurable features including output power defaults, selectable input filtering time, and an output pulse test function.The IC660BBD022 I/O module has diagnostic features and safety measures that easily alert operators to runtime and operational errors. It easily detects errors such as overload, overheat, short-circuit, no-load, and switch faults. The unit is portable and compact. It saves panel space and measures 8.83 inches high, 4.42 inches deep and 3.56 inches wide.

The IC660BBD022 Signal Source I/O Module has 16 configurable I/O circuits on the front of the module.The I/O Enable and Unit Determination LEDs illuminate when there is activity on the module. A monitor port is provided for connection to a handheld programmer, and the I/O block can be easily connected to a PC running the Windows operating system.The IC660BBD022 I/O block dissipates 68.8 watts of heat when operating at 2 amps of current. It generates a maximum ripple of 10%. The module has a maximum switching frequency of once per second and a high inrush current. The maximum output turn-on delay is 1 millisecond. The operating ambient temperature should not exceed 60 degrees Celsius.

IC660BBD022 is a Genius Block I/O formerly manufactured by GE Fanuc and now owned by Emerson Automation. It is a 16-channel source I/O module with channels independently configurable as inputs and outputs that accept 24 VDC input signals and provide 24 VDC / 48 VDC signals. It is compatible with 3-wire sensors, electromechanical relays, and other signalling devices. It supports the Genius communication protocol and can be used as a standalone remote I/O module.