The IC695ETM001 is a PACSystem Rx31 module manufactured by General Electric, which was recently acquired by Emerson.

The IC695ETM001 is a two (2) port Ethernet transmitter module that enables Ethernet connectivity and supports 10/100 Mbps transfer rates and auto-negotiation.

The IC695ETM001 is a single-slot module that fits into the RX3i slot. It enables PACSystem to communicate with other controller platforms such as Series 90 and VersaMax controllers.

The module is capable of implementing Service Request Transport Protocol (SRTP), Modbus TCP, and Ethernet Global Data (EGD) protocols over a four-layer TCP/IP (Internet) stack.

This Ethernet Transmitter Module supports periodic data exchange over Ethernet Global Data, executing EGD commands to read and write to the controller.

It also supports TCP/IP services using Serial Real-Time Transport Protocol (SRTP) and SRTP channels.

It can act as a MODBUS TCP server and MODBUS TCP client.

It has an embedded switch that can be configured for auto-negotiation, sensing, speed and cross detection.

The module can also be used for time synchronisation with SNTP time servers over Ethernet TCP/IP.

The IC695ETM001 has an Ethernet processor speed of 200 MHz. it is equipped with LED status indicators.

The IC695ETM001 has Ethernet processor speed of 200 MHz. It is equipped with LED status indicators such as Ethernet OK, LAN OK, Log Clear, Individual Port and Speed LED status indicators.

The IC695ETM001 can be installed with compatible backplanes IC695CHS007. CHS012. or CHS016.

It is compatible with any other PACSystem RX3i module except the CPE400. It is best installed on an unpowered RX3i backplane.

However, it also supports plugging in when power is present or when the processor is in run mode. This is also referred to as the hot-swap feature.

Firmware version 2.51 must be installed to enable hot plugging.

The IC695ETM001 module also provides an RS-232 serial port that supports data rates from 1200 bps to 115200 bps.

The module’s built-in Station Manager feature is accessible via both the serial port and Ethernet connection and provides monitoring access.

Services provided by the station manager include commands for polling and controlling stations, access for monitoring statistics, logging and configuration parameters, and password security.

The IC695ETM001 module can be used to synchronise timestamps exchanged by the EGD via the SNTP protocol.

Functions of the IC695ETM001 module include PLC configuration and programming functions, periodic data exchange via EGD,

The IC695ETM001 module can be installed in any empty RX3i slot.

The IC695ETM001 module is hot-swappable. Module firmware www.abb-drive.com can be field upgraded using software tools provided by GE Fanuc.

What are the compatible RX3i backplanes that plug into the IC695ETM001?

Compatible backplanes are IC695CHS007. CHS012. or CHS016.

How many Ethernet ports does the IC695ETM001 transmitter module have?

It has two (2) Ethernet ports and supports redundant I/P addressing.

Can I use this module at 1Gbps?

No. It only supports 10 / 100 Mbps. It only supports 10 / 100 Mbps transfer rates with auto-negotiation.

The IC695ETM001 module is an Ethernet module that enables GE Fanuc’s RX3i PacSystems family of devices to connect to VersaSystems via Ethernet.

The IC695ETM001 module is an Ethernet module that enables GE Fanuc’s RX3i PacSystems series devices to connect to VersaMax, Series 90. and other RX3i series GE controllers via Ethernet.