Functions

– 64-bit differential or high voltage digital inputs

– Each group of 32 inputs can be monitored by jumper selection:

Contact closure, voltage source, current sink, or differential signal.

– Open provides logic zero or (jumper selectable) logic one.

– Input filter options

– On-board built-in test logic

– Front panel with fault LEDs

– Front panel with fault LEDs for fault detection and isolation

– User selectable input voltage thresholds (1.25 to 66V)

RS422/RS485-compatible differential line receiver provides ± 7V noise immunity

– 8-, 16-, or 32-bit data transmission

– Dual Eurocard form factor

– High-reliability DIN-type I/O connectors

– Compatible with GE Fanuc Embedded Systems’ family of intelligent I/O controllers (901x and 906x series)

– Boot Replacement Option

– Software compatible with VMIVME-1110

Functional Features

Compatibility: Compatible with VMEbus specification. Double height form factor.

Input Connector Type: Dual 64-pin connector – DIN 41612

Input/Output Organization Eight input ports; eight bits wide. Addressable to any address within the www.abb-drive.com short-circuit monitor and/or short-circuit unprivileged I/O map. Control and Status Register (CSR) addresses are independently selectable.

Addressing Scheme: Each of the eight ports can be addressed on 8-, 16-, or 32-bit boundaries. One CSR can be addressed on 8-bit boundaries. 13 jumpers provide unlimited short data I/O address mapping options.

Differential Signal Input Characteristics: Common Mode Input Voltage Range: -30 to +66 V. Common Mode Input Voltage Range: -7 to +12 V. Input Sensitivity ± 100 mV. High Input Impedance (33 kΩ).

Single-Ended Signal Input Characteristics: High input impedance (33kΩ). Threshold accuracy of 1% (typical) over the entire 66V range.

Signal Conditioning Input Filter Terminator Option: The board can be ordered with an input signal filter circuit.

For differential inputs, the circuit consists of a series resistor and capacitor connected across the signal input. For single-ended inputs, the circuit provides an input dither filter with a user-selectable time constant.

Built-in Test: The board is designed with internal self-test logic to test all active components.

Special output registers are provided to generate 16-bit data words for worst-case bit patterns to be used as health tests during real-time or off-line operation.

A special test mode bit in the CSR enables the output test register to drive a differential receiver.

The front panel fault LED illuminates at power-up and can be programmed to go out after successful completion of user-defined diagnostics.

Related Product Recommendations:

IC660TBD024K GeniusI/O Terminal Assembly Module

1769-OF8C Analog Output Module

350040M 176449-01 Proximity Monitor Module

DS200LDCCH1AGA Drive Control/LAN Communication Boards

CA5-01 Auxiliary Contacts Front Mounting Block Screw Clip

CE3007 KJ2005X1-BA1 12P4375X042 Module

CE30089 Controller Module

MMS6110 Machine Monitoring System Signal Converter

MMS6120 Dual Channel Bearing Vibration Measurement Module

MMS6210 Machine Health Monitor